How do I reset PowerChute network shutdown password and username?

How do I reset PowerChute network shutdown password and username?

To change your username or password:

1. Stop the PowerChute service.
2. Go to the group1 directory where PowerChute is installed.
3. Make a backup of the pcnsconfig.
4. In the group1 folder, open pcnsconfig.
5. In the [NetworkManagementCard] section of the INI file, set the following lines with your new values:
6. Save pcnsconfig.

What is the default password for apc UPS?

The default user name is device, and the default password is apc.

How do I stop PowerChute?

To start or stop the PowerChute service on Windows using the Services console:

1. Click Start > Run.
2. Type Services. msc to, and click OK.
3. Click on the service named PowerChute Network Shutdown.
4. Click on Start the service or Stop the service to start or stop the PowerChute service.

How do I factory reset my APC PDU?

Resetting APC AP7920 PDU

1. Press and hold the reset button for about 10 seconds.
2. The status light should blink rapidly.
3. Release the reset button then press it again for about a second.
4. The light should go orange.
5. After about 20 seconds the reset will complete and the device will have booted.

What is the default IP for APC Network Management Card?

By default, the APC AP9630 NMC (Network Management Card) does not have an IP address assigned. The easiest way to configure an IP address is to log into the UPS’s NMC over a serial port.

Is there a way to reset a password on an APC account?

In addition to possibly needing to reset its password, you may need to re-enable the account if no other administrative access is available or known. To do that, type: user -n apc -e enable. Because the Super User can also reset the password for any account, you can reset other user’s passwords as well.

How to reset APC PowerChute admin passwords?

To reset the Network Manager card you connect with the serial port and press reset and then press it again. Then wait about 10 seconds for it to come back on and the default username and password are set. Was this post helpful? Thanks for your feedback!

How do you reset password on APC netbotz?

Press the Reset button a second time immediately while the LED is rapidly flashing – which will cause the LED to then go off – in order to reset the User Name and Password to their defaults temporarily (the default User Name and password are both apc). 6.)

How do I Reset my Password on my AP9606?

NOTE: If you are using an AP9606, proceed to step 7. Press the Reset button again a second time immediately while the LED is rapidly flashing – which will cause the LED to then go off – in order to reset the User Name and Password to their defaults temporarily (the default User Name and password are both apc). 7.)