How do I access the HP ProCurve Switch web interface?
To enable web login, log in to the device via the console port, and perform the following configuration: • Enable HTTP or HTTPS service • Configure the IP address of the VLAN interface • Configure a username and password The device supports the following web login methods: • HTTP login: • HTTPS login: The following …
How do I reset my HP ProCurve 2610 to factory settings?
To execute the factory default reset on the switch, perform these steps:
- Using pointed objects, simultaneously press both the Reset and Clear buttons on the front of the switch.
- Continue to press the Clear button while releasing the Reset button.
- When the Self Test LED begins to blink, release the Clear button.
How do I reset my HP ProCurve 2520 to factory settings?
To execute the factory default reset on the switch, perform these steps:
- Using pointed objects, simultaneously press both the Reset and Clear buttons on the front of the switch.
- Continue to press the Clear button while releasing the Reset button.
- When the Self Test LED begins to blink, release the Clear button.
What kind of cable do I need for HP ProCurve 2610?
In this guide I am going to show how to perform a very basic setup of a HP ProCurve 2610 Layer 2 network switch using a serial to console cable. First up you will need a serial to console cable and a PC that has a serial port.
Why does HP ProCurve 2610-24 switch default web interface?
Here is the manual. According to that, the process of clearing the config requires a reboot so if you haven’t rebooted, you haven’t cleared the config. There is a suggestion for a backdoor here. That also requires you to remove all cables and connect a cable between 2 ports in a special way, and causes a reboot I think.
How to add password to hp 2610 switch?
A 2610 would have shipped with no password enabled and it would go straight into Manager (Enabled) mode via the console port. You add a named account in via “password manager user-name [name]” in a config context from looking at a 2610-24 I have. I would telnet/SSH into the switch and see if you can grab the config and then reboot it.
Can a hp 2610 go into Manager Mode?
If you did a hard reset, I think you may need to telnet into it and configure passwords/make sure HTTP is enabled. A 2610 would have shipped with no password enabled and it would go straight into Manager (Enabled) mode via the console port.