What does the spring in a stapler do?
The spring creates tension that pushes the staples toward the front of the stapler. When pressure is applied to the head of the stapler, the magazine pushes down on the paper, and a metal plate in the head of the stapler pushes the front staple down the magazine. This releases the magazine and head of the stapler.
How do you get a stapler back in?
Back load staplers usually have a button on the back, so to open these, push the button until the stapler tray pops out slightly. Then, pull on the staple tray until it is fully extended. Electric staplers will also have a release button on the back. Hold the base steady when opening a stapler.
How do you fix a stapler jam?
The Process of Unjamming a Stapler:
- To start, open the stapler completely so that the top and bottom are in a horizontal line.
- If unable to shake the jammed staple out, try to staple a single sheet of paper while the unit is jammed.
How do you fix a stapler problem?
Use a sharp object to push the jammed staple up from the bottom. Any of the following should work: tweezers, scissors, a flathead screwdriver, or needle-nosed pliers. Push the prongs of the jammed staple upward to try and loosen it from the grip of the stapler.
How do you staple without the bottom?
3 Answers
- Put the paper on a soft but firm surface like a piece of Styrofoam, or even a couple layers of corrugated cardboard (like from a cardboard box).
- Open the stapler. Position the head where you want the staple to go through the paper.
- Remove the paper and staple from the soft + firm surface.
Why are there 2 settings on a stapler?
The common office stapler has two settings to provide the user a choice of whether to firmly bind papers together using the “reflexive” or staple setting, where the legs of the staple curve under for a firm hold, or to temporarily bind them with the milder “pinning” setting, which makes it easier to remove the staple …
How can I get the spring out of my stapler?
Open the stapler by gripping the handle to access the spring. Pry open the hook found on the pusher using the tweezers. Hold the handle firmly to prevent the stapler from snapping back. Unhook the end of the spring from the pusher. Pinch the spring firmly between your fingers to keep it from snapping back.
Why is my staple gun not working properly?
If nothing is coming out of the stapler at all, a staple jam is most likely the issue. Open the staple gun and remove the bar of staples. Slide the spring back and forth to check that the staples are able to freely be forced out. If the spring will not move, there might be a staple lodged in the guide rails or around the spring preventing motion.
How can I test my staple gun spring?
To test your spring, open the stapler, slide it back, and let go. The spring should rapidly contact the bar of staples. If the spring’s reaction is slow or not forceful enough, a replacement is needed.
Why is my stapler stuck on the machine?
Whether you are using an automatic or manual stapling machine, the machine can get stuck due to the pin. Sometimes as you press to staple, the pin may come out at the wrong angle. Duh! The machine gets jammed. This type of jamming is easy to fix.