Is it easy to fit bath taps?

Fitting new bathroom taps should be a straightforward enough project to take on yourself, so long as you use common sense and follow simple instructions. Obviously, where water is involved, if you make mistakes then things can go wrong quickly, so check out our step by step guide below on how you fit new taps.

Are bath mixer taps a standard width?

I am replacing standard taps with a Mixer tap. However their is a standard width between the pipes for most new Mixer taps 180mm.

Do you need a plumber to install a mixer tap?

1. Always use a plumber to install your mixer tap. By law, if you don’t have a plumbing license, you can not install or adjust your cold or hot water pipes. When a tap mixer is installed, the hot and cold water flexes are classed as water pipes.

How do I remove a mixer tap from a bath?

Use an adjustable wrench and undo the tap connectors that hold the supply pipes to the tap tails. From above ensure the bath tap is supported to prevent it from turning. Underneath, loosen the nuts with the appropriate tool and the remove the tap.

Do all taps fit all basins?

Not all taps and countertop basins will be the same size, so you’ll want to make sure that there is adequate space from the top of your countertop basin to where the spout exits on the tap. Always check the dimensions of the tap you’re buying, as well as the area that you’re fitting it in.

How are bath mixer taps measured?

Just measure the centres of your tap. Mark on bath to check that it sits on correclty & that you can connect pipes without fouling the wall & bath panel. Measure, check measure & check before you drill ! If it’s an acrylic bath a standard 30mm holesaw should do the job comfortably.

Do all taps fit all baths?

Choosing your bath taps Most baths don’t come with pre-drilled holes so you can choose any model tap that you like the style of, but make sure you check the product information if you’re buying a new bath too.

Can you replace two taps with a mixer tap?

Modern houses and builders are now featuring mixer taps, where one can draw hot and cold water supply from two different sources, but still can flow and come out in a single tap. If you replace two taps with a mixer tap, you’ll also save on your bills because most mixer taps are fitted with flow limiters.

Can I change two taps to mixer?

Hi, you can fit a mixer tap as you can buy a blanking plate for one of the existing tap holes. Two things to consider your new mixer will not be centre so may not look how you visioned. Also you need to look for a mixer tap with out a pop up waste as may not fit correctly, so a clicker waste would be more suitable.

Is it easy to install a bath mixer?

Installing a bath mixer tap should be a straightforward task. But if you are replacing an old system, you may have to make some adjustments such as adding some reducers or compression fittings. From fitting the tap to connecting it to the shower head, follow our guide to learn how to install your bath mixer tap.

How to renew bath taps to shower mixer taps?

How to renew bath taps to shower mixer taps. Giving you a free shower. – YouTube How to renew bath taps to shower mixer taps. Giving you a free shower.

Do you need to unpack a bath mixer tap?

The Dulwich bath shower mixer from The Bath Co. is a traditional style bath shower mixer tap Always unpack your tap immediately after delivery. Check for any damage or faults as it’s better to find them now, rather than during installation. Always turn off your water at the mains before attempting any DIY in the bathroom. Usually supplied with tap:

What kind of tap do I need for my shower?

First things first, you will need to identify which type of bath tap you have. They mainly fall into 2 broad categories: Mixer taps—1 tap which combines both hot and cold water. These sometimes include a shower fixture too, known as a bath shower mixer tap.