How do you make a handprint keyring?

How do you make a handprint keyring?

Directions:

1. Start by placing the shrink plastic on a table.
2. Have the kids press their hands against a rainbow ink pad.
3. Have them firmly press it against the plastic.
4. Over the wet ink, shake embossing powder and tap off excess.
5. Cut around the edge of the handprint leaving a little space.

How do you make a Shrinky Dink keychain?

Directions

1. Preheat oven to 300-350 degrees F.
2. Trace or freehand a design onto the film.
3. Cut out your design with scissors or a craft knife.
4. Use a hole punch to add hole for keyring PRIOR to baking.
5. Line a cookie sheet with a piece of parchment paper.
6. Bake for 2-3 minutes.

How do you make homemade Shrinkies?

Instructions

1. Locate a flat piece of #6 plastic.
2. Preheat your oven to 350 degrees.
3. Using permanent markers, decorate shapes and designs on the plastic.
4. Cut out the plastic, with the knowledge that it will shrink down to about 1/3 it’s original size.
5. If you plan to make a charm, punch a hole in your design before baking.

What do you use to make a father’s day keychain?

Loop your string through the hole and add some beads like in the picture above. We used 5 beads for each keychain which seemed to work well. Tie the string onto the key ring with a couple of knots, pulling tightly and trim the excess string. You can also dab the end of the knots with some super glue for reinforcement.

What should I get my dad for Fathers Day?

Dad Keychain, Fathers Day Gift For Dad. This daddy Belongs to… Round Polished Personalised Keychain. Fathers Day Gift, Eched Laser Keyring

What does a dad keychain look like on Amazon?

This keychain has a personalized look. It is strong and sturdy, and its material ensures that it can last a long time. This keychain has a personalized look. It is strong and sturdy, and its material ensures that it can last a long time.

How do you make a keychain out of Shrinky Dinks?

Once your shrinky dinks are cooled down, you can make them into keychains. Loop your string through the hole and add some beads like in the picture above. We used 5 beads for each keychain which seemed to work well. Tie the string onto the key ring with a couple of knots, pulling tightly and trim the excess string.